New builds
New Construction Wiring in Brier
Brier builds are mostly infill and tear-downs, and both reward getting the service size right at the start.
The whole scope, one crew
Most new building in a city this size is a tear-down and rebuild on an existing lot, which has one useful consequence: the old service is right there to learn from, and you get to size the new one for the next thirty years rather than the last. We take the whole scope — temporary power, service entrance, rough-in, inspections, trim — so there is one figure, one crew and one set of dates for your builder to work to.
What is included
Temporary power and the service entrance
Power on site when the trades need it, permanent service established with the utility.
A full rough-in
Every circuit run, boxes set, lighting layout walked with you before anything is covered.
Inspection management
Rough and final inspections filed and attended, timed so the build is not waiting on us.
Final trim and handover
Devices, plates and fixtures, tested, panel labelled, paperwork handed over.
Where we fit in
Plans at permit stage
The best moment to involve us; decisions cost nothing to change now.
Framing complete
Rough-in slots into the window between framing and insulation.
Several trades on site
We work to the construction schedule and tell your builder directly if anything moves.
An owner-built project
We are used to owners running their own build and will flag the early decisions.
How the work runs
Price the plans
A full scope and a fixed figure from the drawings.
Temporary and service
Site power early, permanent service coordinated with the utility.
Rough-in and inspect
Run, walked with you, inspected before close-up.
Trim and hand over
Fixtures and devices at the end, tested and documented.
Questions about this work
Do you work with our general contractor?
Yes, and most new-build work arrives that way. Your builder gets dates and a direct number.
Can we change the lighting after rough-in?
Small changes sometimes; anything structural is far cheaper before.
Should we size the service for future loads?
Almost always. Allowing for a charger and a heat pump at build time costs very little and retrofitting costs a great deal.
Price the electrical on your build
Send the drawings or call. The quote and the planning conversation are free.